Our UK straight router cutters come in a wide range of sizes allowing you to accurately cater to your project. These bits are used to cut straight into a material to hollow out a section or to create a groove. A down cut router bit is effective in forming a crisp edge around the hole that it is cutting. However, it is less effective in removing chips from the hole when compared to an up cut bit. Therefore, down cut bits are more commonly used for making shallow cuts rather than deep grooves. One important thing to take note of is that if you do use the spiral router bits on a router table, then the downcut bit will actually push material towards your workpiece, sometimes raising the workpiece off the table. It will still make a clean edged cut, but it is important to use a good downward feather board system to prevent the workpiece lifting. Take light passes when using it on a router table. CNC stands for Computer Numerical Control. Our CNC router bits are compatible with computer-controlled routers. CNC routers are particularly versatile as they can perform the tasks of the boring machine, the spindle motor, and the panel saw. A router tool has a flat base and a rotating blade that is driven by a motor. They are considered an extremely versatile power tool and can either be handheld or attached to a router table. Our UK router bits are imperative to achieving your desired design in whatever material you are working with.

An up cut bit is typically used to remove chips from the hole that it is cutting. Deep grooves need to be fashioned out using continual light cuts. Up cut bits are ideal for this as the upward direction of the flutes inhibits the build-up of debris which can either break or bind the bit. As the flute removes chips it can simultaneously fray the wood fibres, causing damage. You must be mindful of this when using up cut bits and be careful to avoid implementing damage to your project. A slower feed rate is required with down cut bits as this allows more time to evacuate chips and for them to be cut into smaller pieces that fall from the slot. This does mean that you need to be careful the bit does not overheat and consequently break. This can be due to the build-up of chips combined with a deep cut.

Sign up for special offer emails