I still wont put it in my boiler as im all but 'must be natural' semi organic leaf hop no pellets no plastic no poison man but then I probably shouldn't be drinking beer.

but I've not seen it visibly degrade over time in the boiler, so combined with the relatively small quantities contacting a lot of beer then I personally struggle to become very concerned about it. We’ve built our reputation on reliably supplying plumbing products delivering to companies of all sizes as well as home owners and DIYers. This is one of my go to products when you have that annoying weeping on a joint PTFE and the product on the joint problem solved. We also track your visits using Google and Facebook, along with serving personalised ads via AdRoll. For me though, with LS-X being suitable for potable and hot/cold water thats enough for me to treat it 'essentially' as food safe in in HLTs.Fernox are the originals and a few other manufacturers produce similar now but to be honest I’m sure normal silicone would work just as well.

P302 + P352 IF ON SKIN: Wash with plenty of water/…P332 + P313 If skin irritation occurs: Get medical advice/ attention. All I see is LSX plastered all over boilers in an attempt to stop leaks instead of a fibre washer or O ring being replaced. Steve B wrote:It's food safe - I've used it to seal things in my brewing setup - no discernible off tastes or anything that I've noticed. It is the superglue of sealants, and is not removed by water even when fresh from the tube (well durr! To calculate the overall star rating and percentage breakdown by star, we don’t use a simple average.If you need to seal a little weep on a fitting or boiler part till you can replace it works a treat and you can apply it wet and it sets up in 30 minutes. Some mention that it's been 3 months with not a single drop of water, while others say that it stays wet and does not dry. Apply LS-X direct from the tube and mould into shape using a spatula or knife previously dipped into soapy water to prevent adhesion or dragging. If u have a slight weep, unfortunately the best thing to do is take the nut apart and add LSX to the olive. After what recently came to light (news to me anyway) over polycarbonates, who knows for certain - even the things acredited as food safe are potentially not, these days!

It seems to work well, even on one joint that couldn't be fully tightened as it was a right-angled joint and had to point the right way.An alternative for permanent fixtures is JB-weld, but its a similar story with that - the manufacturers say its non toxic (when set) but again thats not 'actually' a guarantee of being food-safe in hot wort or the after cleaning chemicals one may use. Fil recommended it ages ago so I gave it a good looking into but the only thing I found was that it was suitable for potable water. Use it all the time for making tank connections in on cold water tanks , I always use it when making shower tray wastes in and I’ve never had a problem .

I would not recommend for sealing leaks, as it advises in the leaflet that is in the box, Araldite multi-purpose putty is better for that. Some mention that it sticks to most surfaces, including PP (polypropylene plastic) and makes a fantastic anti slip product, while others say that it's not quite as sticky as most glues and leaves a tacky mess until it dries. products_related:7577,7578,1,20191,6962,20294,12764,21064, sku:7578 Leak Sealer 7577,7578,1,20191,6962,20294,12764,21064, 7578 7. I wanted to use some, if suitable to bed and seal a through the hull fitting to the bottom of my mash tun or if there is a better option fire away.And by now BOTH of my hands were coated with the LSX I won't go into every detail, but I am sure you can imagine the situation!