Apply a thin coat of either Dark or Bleached Liquid Wood in small sections at a time about the size of a wood plank. This is so that the Liquid Wood does not have time to dry before you grain it. If you're staining a very large surface (like a dining room tabletop), then keep a bowl of water on hand to dip and lightly squeeze excess out. Always remember to generously dip your sponge into the stain. Never overwork your stain or allow your sponge to get dry. Using a dry sponge to apply Retique It® waterbased gel stain may cause streaking.

Cuttwood are a high end e-liquid manufacturer hailing from Irvine, California in the good ‘ol US of A. Cuttwood E-Liquid is proudly made in the USA to exacting quality and hygiene standards. Their superb range of e-liquid flavours includes cereals, desserts, creamy custards and authentic tobaccos – something for every vaper and every time of the day. Earlier liquid wood was not safe for household products because of the high amount of sulphur present in it. But later German Researchers were able to reduce sulphur content in liquid wood or Arboform by 90 per cent making it safe to use in day to day life. Benefits of Liquid WoodWhile the liquid wood is still wet, pull your graining tool in long even strokes across the entire piece. Rolling the graining tool up or down will create the grain variation and knots. Do not stop when pulling the graining tool from one end of the surface to the other. Try keeping one long continuous movement. NOTE: If you received 2 liquid wood shades in a kit, then the smaller container of liquid wood should be used as the graining coat. Get out your yellow sponge applicator to wipe on your Retique It® water-based gel stain. (Make sure you wet your sponge with clean water and squeeze out just prior to staining as this will prevent streaks) Retique It liquid wood is used to put an unfinished wood layer on any surface. It is suitable for furniture, cabinets, doors, drywalls and metals. Retique it is easy to apply with a paintbrush or paint spray. After that stain the surface with your favourite colour.

The future of liquid wood is bright. Future toys, food containers and car bodies will be made with liquid wood. Arboform is a future material and researchers believe it will be in use in most areas and has true value. Harsh chemicals and even fragrances have the power to wear down the finish of your wood floor's natural shine and value. The Cuttwood E-Liquid collection features liquids with varying VG and PG content, but most are aimed at the cloud chasers with 75% VG being the typical formula. This is particularly important if mopping or scrubbing your wooden floors with a water mixture. That's why working in small sections is advised, as it means you can dry them with a clean cloth or dry mop afterwards. Why are some products not safe for use on wooden floors?

Allow the last layer of stain to dry for at least an hour (Using a blow dryer on high heat may shorten your dry time to under 10 minutes for each layer of stain) If you don't like the grain, then pull the graining tool over it again. If you still don't like it, then paint more liquid wood over it and start on that stroke again.