Step 1: An important action to ensure you carry out, is to thoroughly clean and dry the area of paint you are applying the T-Cut to, or else it could potentially damage the paintwork.

It’s vital that all excess fluid is removed before finishing the job. If too much is left on, or the incorrect colour has been applied to scratches, it can be extremely difficult to remove. Applying T-Cut is a time-consuming process and requires additional care afterwards. If the application of T-Cut is rushed then it can lead to more expensive repairs later on down the line. Common Questions Is T-Cut safe?At ChipsAway, we don’t recommend using off the shelf pens. This is because it is so easy to end up with results that look like a bit of a bodge job. If you are attempting to restore your car’s looks, you don’t want to end up with it looking like someone took a Tip-Ex pen to it! Containing no harmful silicones and leaving no residue on your car, the T-Cut Rapid Scratch Remover is a renovation paste, specifically designed to remove those small flaws from your car's paintwork. In conclusion, T Cut is a great choice for everyday use. It is gentle on your car’s paintwork and can help to reduce the appearance of scratches and scrapes. However, it is important to remember that T Cut will only remove the top layer of paint, so it should not be used on more serious damage.

This incredible T-Cut For Cars formula contains no silicones and leaves no harmful residues, preparing an ideal surface for re-painting. Prepare for more than one application Even on shallow scratches we tested on, we found that many car scratch removers needed more than one application to get rid of the scratch. That being said, if you only have tiny, surface marks to repair, this technique could help to disguise them. As with any repair, you’ll need to clean and dry the area first. Then, draw the pen over the mark, the nib is almost identical to a felt tip. However, the damage will still be visible from close up. However, it is important that you use T-Cut correctly. If you apply too much pressure or go over the same area repeatedly, you may cause damage. It’s important to remember that T Cut works by removing the top layer of paint from your car. Whilst this is great for scratches where paint from another vehicle has been left behind, it is not ideal for deeper scrapes and could actually cause more harm than good.

Which T-Cut to use?

Then we set about applying a set of scratches of a measured, even depth to a new car door using a specialist piece of scratch equipment. Applications needed Step 3: Rub the T-Cut over the scratch with a steady and firm hand, ensuring you move the cloth in a circular motion. Do not be alarmed if your clothes change colour, as it is only due to the top layer of paint coming off. Protect your hands with rubber gloves Many of these products contain strong chemicals that can be an irritant to bare skin. If any of the car scratch remover does get on your bare skin, wash it off with soap and rigorous scrubbing. T-Cut Original Colour Restorer – Formula that restores the original colour and shines to paintwork.

Whether you’re contending with the rigours of daily commuting or the fallout of a minor mishap, maintaining the integrity of your car’s vehicle paintwork can pose quite the challenge. Over time, cosmetic damage, such as minor scratches and minor marks, can detract from your vehicle’s appearance. Thankfully, the T-Cut Solution can help restore your car’s former glory. What is T-Cut? We then washed where each set of scratches were with car shampoo and warm water, either until the scratches reappeared or a maximum of five times. If You Rush It Or Don’t Have Time For The Maintenance: As mentioned in step 4, you should always remove any excess product on the car, as it will be tough to remove any that was left over. Yes, T-Cut can help remove excess lacquer. Lacquer overspray can easily be removed with the Original T-Cut cutting compound. Can it remove spray paint? From T-Cut Rapid Scratch Remover for light scratches to T-Cut Metallic Colour Restorer for metallic paintwork, the selection is abundant. Choose the one that matches your specific vehicle needs. Safety FirstThe T in Tcut stands for “ Tetrosyl Cutting Oil ”. How T-Cut works What is the car scratch remover good for?