The clamp to the rear foot of each leg must be modified by fitting a bolt through each claw fitting. The bolt must clamp the rear foot of each leg to the rail, floor and a suitable structural member (as in most vehicles). If you have had an accident whilst driving a works vehicle in work time that has resulted in a seatbelt injury, then you might be able to make a seat belt accident claim. However, depending on the circumstances you could claim from the driver who is at fault, or if your injuries are found to be due to a malfunction or defect of your seatbelt, then your employer might be seen as liable and so you would claim from them. The accident could also be down to the seat belt manufacturer. The bolts must have appropriately sized load spreading washers fitted beneath the bolt head and underneath the retaining nut. A single bolt should be at least 8mm (5/16”) in diameter. Any alternative to this is only acceptable if documentary evidence is provided. You could claim general damages for your pain and suffering as well as special damages to recover your financial losses due to the injury. The compensation guidelines for personal injury found in the table below are taken from the April 2022 edition of the JCG. However, the amounts in the table may not exactly match the amount of compensation you receive in a successful claim as every claim is different. Reason for compensation

Made from durable plastic, includes a high quality tempered stainless steel blade for a clean, accurate cut in situations where time is extremely limited. Product Details: Manual: The manual hammer is either a small tool, shaped like a hammer, that you swing to break the glass, or it’s a small, handheld object that can be jabbed into the window. It requires motion, so if you’re constrained or limited in your movements or strength, the manual tool can be harder to work.The handle is usually made of sturdy material to give more stability when cutting. It’s also typically double-sided, so you can use both hands, making it one of the sturdier options for cutting seat belts. The seat belts are purely designed for safety. They make sure that the driver and the occupants are well and protected all of the time while driving.

Guide to Community Preventive Services. Use of Safety Belts: Enhanced Enforcement Programs. [cited 2010 Nov 24]. Available at URL: http://www.thecommunityguide.org/mvoi/safetybelts/enforcementprograms.html For your child to properly fit in a seat belt, he or she must be tall enough to sit without slouching and be able to: As a rule look for a blunt nosed knife. A sharp point only has use in piercing materials but the obvious danger is piercing yourself or the casualty. The exception to this might be a raft guide who may need a sharp point to pierce the raft to escape when capsized and / or pinned.i) Retro-fitted three point belt fitted to a seat on which the leg and frame has not been suitably modified (see note K) If your seatbelt injury was someone else’s fault, you may have grounds to claim. However, it can be helpful to look at compensation guidelines for personal injury claims to get an idea of the potential worth of your own claim. You could also use our online compensation calculator for an estimate of the value of your claim. If you run out of charge for your cell phone, you can't call for help. A car escape tool with a small, hand-cranked generator can provide enough power to help you make that vital call. H. Seats with a wooden frame that have the belts mounted directly to the frame, or to a metal base that is attached to the frame by wood screws only, must be rejected. The installation cannot be passed unless there are additional reinforcements that provide a direct load path to the seat and leg and side mounting. Stainless steel blades are usually preferred as they are easier to carry around and are also easier to clean. On the other hand, carbon steel blades are usually harder and more durable. They are also easy to sharpen.