A. Finish fascia level with the face of the rafter gable. Soffit should over hang by 10mm and may be cut square or mitred. The box end construction for fascias, soffits and gutters is located on the corners of a property’s gable end. Its purpose is to connect fascias and soffits on the non-gable end to the bargeboards that are situated at the gable end. This gives the corners of the roofline a neat finish. We offer an extensive range of high-quality capping boards, fascia replacement boards, hollow soffit boards and pre-vented soffits. Whatever your need is we can help!

At the corner intersection where the bottom of the Barge board joins the end of Fascia Board, a box section is formed. To construct this section correctly, a larger piece of board called a Box End Board is used. The Box End board enables this bottom section to be formed using a single piece of fascia, without the need for messy joints or infills - all that is required to complete the section neatly are two corner trims. BOX END BOARDUse conventional carpentry tools including fine toothed saws. Power tools may be run at speeds appropriate for timber. Nail and screw holes do not require pre-drilling. Off-Cuts Always leave a minimum 4mm expansion gap at the end of each board, ie where two boards meet leave 8mm overall. Sealants Kayflow unveils latest machinery investment to aid product development and reduce energy consumption Our fascia profiles come wrapped in polythene sleeves with a particular shade of white. We recommend that the protective tape is removed just before installation to avoid damage to the product.

For the next step, you should remove a section from the corner joint that will be used to fit around the rafter. This will be used as the joint for the pieces that were created in steps 2 and 3. Step 5: Attach the bargeboard

Barge board is the name given to the Board that runs up each side of a gable or apex, forming the top two sides of a triangle. It looks the same as a Fascia Board and indeed the same board can be used, although a Barge board does not carry out any supporting structural function on the roof. When replacing old fascias and barge boards you shouldn't assume that they will be the same size - the bargeboard very is often smaller than the fascia. BARGE BOARD Replacement ogee fascia boards with a more decorative finish compared to our standard fascia board. Ideal for new build and refurbishment projects, this distinctive sculptured finish will make an attractive improvement to any home. Choose our standard fascia board for a more traditional finish. Edge Building Products A4 grade stainless steel plastic headed nails or capped screws. See below table. Product Next, measure the required length of your box end and cut it from a deep fascia board. The front edge of this piece should tilt up, so it matches the height of the fascia board that is already fitted. Step 3: Cutting a length to the gable wall Manufacturer guarantees are based on technical testing information obtained from BSI and are valid on the basis that manufacturers recommendations for installation are followed.