DEWALT DXAEPI1000 Power Inverter 1000W Car Converter with LCD Display: Dual 120V AC Outlets, 3.1A USB Ports, Battery Clamps

Product Information

Connect the free end of the fuse or breaker wire to the positive (+) terminal of the DC power source (battery). VENTILATED – Allow at least three inches of clearance from other objects to ensure free air circulation around the inverter. Although the inverter has built-in protection against over voltage, it may still be damaged if the input voltage exceeds 15 volts.

Any unpaid portion not received by the due date will no longer form part of the equal payments plan and interest will accrue on that amount from the day after the date of your next statement at the applicable regular annual rate.Always turn the inverter off by pressing the on/off button, then disconnecting it from the DC source when not in use. Connect the inverter to your battery and plug it in a controlled and limited power like a low voltage lamp. A beep will sound, the backlit LCD and the USB power/fault indicators will activate to indicate the inverter is operating properly and the 120 volt AC outlets are ready to power appliances that draw up to 1000W continuous and USB outlets up to 3. Avoid locations that are exposed to heating units, radiators, direct sunlight, or excessive humidity or dampness. Do not place the inverter on or near a heating vent or any piece of equipment that is generating heat above room temperature.

The following table shows the correct size to use depending on cord length and nameplate ampere rating. If you suspect that it has been damaged, take it to an authorized service center for inspection before using it again. The product might exhibit unusual operation (such as, intermittent operation, buzzing, and the like. The manufacturer warrants this product against defects in material and workmanship for a period of one (1) year from the date of retail purchase by the original end-user purchaser (“Warranty Period”). The AC outlet icon and USB icon will light solid and the Digital Readout shows the total output wattage of AC outlets.Reverse polarity connection may result in a blown fuse and may cause permanent damage to the inverter. Connect the other end of the wire to the positive (+, red) O-ring of the supplied cable set, securing them using the supplied bolt, washer and the wing nuts. When using a rechargeable device, monitor its temperature for the initial ten minutes of use to determine if it produces excessive heat. Then, on the front side of the inverter, you will find the on/off button, press and hold that button until the inverter is switched off.

The two standard North American 120 volt AC outlets and three USB ports are ready to use once the inverter is properly connected to a functioning power source and the power button is turned on.C. If a fault occurs again, make sure that the total draw of all USB devices plugged into the USB ports does not exceed 3. Important Cable Information: Substantial power loss and reduced battery operating time results from inverters installed with cables that are not able to supply full power. D. If an individual USB device is within specifications and the fault occurs, have the USB device checked for malfunction and do not continue to use it with these USB ports.