4 INCH 100MM Round Soil and Vent Condensation Trap with Overflow - Stop Water Leakage Back in to Your Duct Work - DUCTING Fittings by KAIR Ventilation

Product Information

You need to go outside for the final stage, so get your extension ladders out and ensure they’re in good condition. However, If a gable end wall or soffit extraction point is not an option, you may find yourself needing to extract vertically out of your roof using a roof venting kit or venting tile. This now poses a potential problem with condensation. Condensation Trap 100-110mm with Overflow Connection. Fits either 100mm I.D. Pipe or 110mm O.D. Pipe

Please Note. Our "Cut Off Time" if choosing next working day delivery is 2.30pm (Excluding Saturdays & Sundays) Condensation traps are designed to be installed with solid ducting rather than flexible ducting so bear this in mind when you are choosing your accessories for your installation. Note: Some traps have a removable collar top and bottom, so always follow the manufacturer’s instructions on fitting. Doing a dry fit before the final fix is good practice. When doing the final fix, apply glue to the ends of the pipes. The vent pipes will sit approximately 40mm into the trap, leaving a gap of 25mm. I have used Fastlec three times each time I have found them to be efficient fast and happy to give you information on their products."The Vectaire Water Trap has a small reservoir that condensation can collect in and then evaporate during the day when the fan is not in use. It's simple very effective and requires zero maintenance once fitted. Drill a 12mm Ø hole in one corner of the rectangle, then, using a keyhole saw, cut along the lines and remove the boarding section.

If your vent pipe goes straight up through the roof with no flexible connector, follow the steps below: Extractor fans in bath or shower rooms, where warm moist air passes through a pipe to the outside, are particularly prone to condensation. The arrow on the Water Trap shows the direction of the airflow and when mounting the trap this must point away from the fan. After the Vectaire fan is fitted into the ceiling, from above in the loft space, simply push the water trap onto the top of the fan and seal with gaffer tape or sealant to give an air tight seal. I recently fitted a fan in my bathroom ceiling, which discharged through the roof via a plastic pipe.As for installing a vent pipe through a roof, this video on the Roofing Megastore will prove extremely useful. If a product fails after six months of receiving the item it is considered a warranty claim and is the responsibility of the buyer to pay for the return postage. We will then dispatch a free-of-charge replacement once the original has been received and tested. Book a DPD Return Here