Ubiquiti Networks UAP-AC-LITE WLAN

Product Information

In this case, the device is unable to resolve the controller. The controller should be available on https://unifi:8443. If that is working then there is a reason why the Unifi AP can’t connect to it. It might be in the wrong IP range (that was the problem in this case), or it can be a DNS issue. Sixteen 20 MHz DFS channels: 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140, or 144 We have reset one of our Unifi switches (minus the “forget” step) but find that it is still within and controlled by the ISP’s network. We have not done the same with any APs yet. This is also still the case after we had taken this switch off the microwave connection and physically connected it to the outside world through the Fibre connection.

Is there a way to reset, reconfigure, forget these devices (switches, APs, and perhaps routerboards (although they do not show in the topology)) and take them away from control by their system without access to their controller? We have acquired a Unifi Cloud Key G2plus so we can control our LAN from within once we are loose from them. I was hoping to automatically switch to the secondary WAN port which will route to the radios if my Internet connection failed. It did not work. Vouchers : Provide guests with vouchers that can be used to authenticate. Customize vouchers to support various expiration times, bandwidth limits, or data consumption quotas.

Depending on your floor type you will need one for every floor or you can do with just one Access Point on the first floor or ground floor ceiling. If you have wooden floors, you could start with just one Access Point. Place it in a central location without any obstruction for the best coverage. When you have concrete floors, you will need to install an Access Point on every floor for decent coverage. The rebar and concrete weaken the signal too much for good coverage. After the device is rebooted it will be available for adoption again in the controller. Resetting UniFi AP with SSH WiFi extenders are also designed to improve the reach of your wireless signal by doubling your coverage area. These models are the definition of plug-and-play; just plug them into a standard US wall outlet and instantly improve your WiFi experience! However you choose to extend your network, you’ll have a device that can support hundreds of concurrent connections with minimal power consumption. Also, try to place the Access Point in the room where the wifi is used the most and at least 3 feet away from other appliances that send wireless signals at the same frequency (cordless phones and microwaves for example). Also, large metal objects (fireplaces, chimneys) tend to weaken the signal.

AP Exclusions is a list of APs that are excluded from the global rules. You can hit the “X” on the right to apply the global rules, or go to their device settings panel and toggle the global rules there. Effect: Enabling allows devices that support UAPSD to save battery power by keeping their Wi-Fi radio in sleep mode for more time. Like a lot of features that are off by default, this can cause issues for some clients, especially older or IoT devices. This is required for some IPTV providers, and is another setting to consider when troubleshooting multicast issues.Ensure that your power and network connections are secure. If they are, but your issue persists, we recommend using our UniFi cables for optimal compatibility and performance. Verify Your UniFi Console's Internet Connection Jumbo Frames allows for the use of Ethernet frames larger than 1500 bytes, which is the standard size of an Ethernet frame.