APC AP9630 UPS Network Management Card 2

Product Information

Description: Configure the command line interface prompt to include or exclude the account type of the currently logged-in user. Any user can change this setting; all user accounts will be updated to use the new setting. To detect internal problems and recover from unanticipated inputs, the Management Card uses internal, system-wide watchdog mechanisms. When it restarts to recover from an internal problem, a System: Network Interface restarted event is recorded in the event log. Network interface watchdog mechanism You can access the command line interface through Telnet or SSH. Telnet is enabled by default. Enabling SSH disables Telnet. Run a terminal program (such as HyperTerminal ®) and configure the selected port for 9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control. Connect to theUPS/device serial port using the correctAPC configuration cable. Part numbers are below for common devices. Please refer to the User Guide if you are not sure or your device is not listed.

Local access to the command line interface from a computer with a direct serial connection to the Management Card The command line interface provides options to configure the network settings and manage the UPS and its Network Management Card (NMC). How to enter commands WARNING!- Connecting anon-APC serial cable to your devicecan causeunwanted, erraticdevice behavior. Device Description: Configure the shutdown parameters: this enables you to show and configure UPS Shutdown Delay, UPS Return Delay, UPS Low Battery Duration, UPS Sleep Time, and UPS Min Return Runtime.PNS shows that is cannot communicate with IP of the NMC on either port 80 or 443." Did you mean to say the PCNS can communicate on either port 80 or port 443? If it cannot communicate on either of those ports, you want to make sure any firewalls you have are open on those ports in both directions.

The User field reports whether you logged in through the Administrator or Device Manager account. (The Read Only User account cannot access the command line interface.) PowerChute Network Shutdown — Provide unattended remote graceful shutdown of computers that are connected to UPS devicesShips with AP9630 pre-installed in units manufactured post 2012. Older G7000 models require a special upgrade kit pre-2012 manufacture date.

bps, 8 data bits, no parity, 1 stop bit, and no flow control for initial configuration, 2400 bps for NMC configuration - refer to user's manual for more informationAfter connecting the correct cable, start the terminal emulation program of your choice. Configure port settings appropriately for the device you are attached to (refer to the User Guide for the particular device). Commonly usedport settings are as follows: These commands are only available on the MGE Galaxy 300 and MGE Galaxy 7000 UPS. Some options may only be available based on the individual UPS model. The first issue I had is that the Forum post you linked in your first comment above is no longer accessible, the frontend of the forum appears to be up but all the post I try to access return a application error. the Knowledgebase which appears to be on the same system works but I have not found anything solutions that resolve my problem. Note : SUVT model UPSs with v7.X.X firmware should use NMC2 to take advantage of all UPS firmware enhancements.