The Q™ controller is activated by a proximity sensor on the front of the controller. The sensor detects motion from 0.5 to 0.7 meters directly in front of the device. It is important the device is positioned so that it will detect the user approaching and moving away from the shower. Insert the data cable wires following the colour sequence marked on the wall plate. In this video I'll be showing you how to install an Aqualisa Q™ concealed controller. When installing the concealed smart-shower system the pipework and data cables should be installed prior to tiling. Concealed cables must be protected by a suitably sized conduit to allow for removal in the event of service or maintenance. Think about the location of the Q™ controller. Choose a suitable height so all the family can easily see and use the controller.

Carefully remove the wall plate which will be secured using silicone sealant. This will expose the PCB which connect to the control knobs. Shower control (vertical orientation) On the underside of the control you will see the clip – press in to release the control. The Aqualisa 25mm pinch grip shower head holder - chrome/satin (910269) is a genuine, brand new Aqualisa product, covered by a minimum 1 year Aqualisa manufacturer's guarantee.

Flow & Leak Questions

Unless like for like, electric showers are not considered direct replacements. Recommendations for an alternative is based on cold water inlet connection type / location, electrical wiring location and current KW rating. Shower footprints differ along with fixing points so new holes will likely be required or may leave old fixing points on visible. The wall will need to be fully tiled beneath the existing shower for the installation to be completed.

Exposed control (rail through ceiling) / pre 2007 concealed models - Push the control upwards, and the retaining ring will move to release the control from its lower securing lugs.Aqualisa iSystem exposed digital bath shower with adj shower head & bath filler overflow - HP/Combi It is of the Aqualisa pinch grip variety. The bit that grips the riser is fine. Just the side that the shower head slots into causes the shower head to be loose. The ratchet appears to be ok. On the underside of the control mounting box, you will see 2 self-retaining screws with cross-heads – remove the screws to release the control.