Joined in 2023 
82 
63 About this deal
If your fence has been stained or painted before, you might need a little extra prep. If stained, just clean, rub down and test the new stain on a small, out-of-the-way area to see how it looks and how well it goes on. If painted, scrape off any flakes with a decent paint scraper and give it a good rub down before painting.
Key specs – Finish: Matt; Volume: 5 litres; Drying time: 5 hours; Coverage: 4m² per litre; Coats required: 1-2; Weather protection: 2 years; Available colours: 4 Protecting wood for two years, One Coat goes on easily and is showerproof in as little as one hour (climate dependent), and as One Coat only requires, well, one coat, you can have the whole job done and dusted in next to no time, leaving you to go and do something far more interesting instead. The best paint to use in this scenario is a specialist fence or exterior paint. There is also the option to choose from stain or paint, depending on what type of finish you want. Just make sure that you follow the instructions: wear gloves and a mask and take care to cover nearby surfaces from unwanted paint spatters. Water-based and harmless to pets and plants, actual coverage achieved depends on whether you’ve opted for brush or gun and on the surface you’re covering, but as a rule you’ll always get more coverage using a brush than a spray gun.Both types of product usually contain anti-mould elements and an ingredient that will help waterproof your fence panels, to stop any moisture from getting in and rotting the timber. When Should You Paint Your Fence Panels? If you need to give your metal fencing a much-needed makeover, then Direct to Rust Metal Paint from Hammerite is a hassle-free, time-saving option. Very few people genuinely relish the opportunity to paint their garden fence, and even fewer want to spend hours on a warm, dry day giving their fence two coats of paint. Fortunately, One Coat Fence Life from Ronseal does exactly what it says on the tin. If you’re concerned that sprucing up your panels is going to draw attention to the poor repair of your concrete fence posts, then fear not: Sandtex Ultra Smooth Masonry paint can save the day.
There are several options to consider when painting a fence. We take a closer look at each one, its pros and cons, and how best to apply.The other benefits of this paint is that it can be applied directly onto even rusty metal using a paint brush or roller – although you need to remove all loose rust and flaking paint first – and it gives up to eight years of protection from the weather. Cover adjacent plants and grass with a plastic dust sheet to protect them from the cleaning detergent. Once you have a clear space around your fence, think about covering the surrounding vegetation (essential if spray painting) and laying down dust sheets or plastic sheeting along the bottom of the fence to catch any paint drips. Next, get your roller — start at the top of a section and work across and down. This will help smooth out any drips that might land below where you are painting.
Available in six natural wood colours, One Coat is formulated for use on new or previously stained rough sawn wood and can be applied using a brush or by spray. A five-litre tin is capable of covering six standard fence panels. If your fence panel is still wet when you start painting, the paint won't adhere properly to its surface. This can cause unsightly bubbles, and the paint simply won’t do its job properly. A panel should take around 15-30 mins to paint, depending on how precise you are. This is the slowest method but also the simplest, as you only need a brush.One final nice touch is that Sandtex’s special Microseal formulation is dirt-resistant, so your posts should remain pristine with a minimum of intervention on your part. Great news. Start by filling your sprayer's container with paint. Switch on your sprayer and start in the top right or left corner.
Great Deal 
New Comment