Caution! Failure to use the clamps could result in flooding if the hoses come loose from the Y-connector. A newer version of this kit will include a drain Y-connector with a 1 inch hose stopper built-in to prevent the hose from being inserted too far. Please read through the instructions or watch this video in its entirety before attempting installation and be sure to pause the video when necessary.

Then connect the long hose from the dryer kit to the other side of the Y-connector and tighten firmly. Mount the main washing machine using all 16 screws, 4 on each side of the unit using a Philips screwdriver.

The main washer cold inlet hose and connect it to the cold water faucets Y-connector and tighten both firmly. Insert the hybrid drain hose into the drain Y-connector between the 2 washer drain hoses up to the tape mark.

Adjust the 4 main washing machine feet down about 1/2 turn to tighten them against the pedestal for stability. In this special case where you have a hybrid dryer, it is necessary to connect the dryer drain hose.