Typically: shopping centres, supermarkets, industrial processes and buildings with a highly combustible load. Pumps: 1 pump with horizontal baseplate with an electric or diesel motor. Pump with split housing for easy access to the inner pump components without having to dismantle the motor or piping Please note an 8 hour double-walled fuel tank is as per the requirements in Factory Mutual Datasheets. Within NFPA20 a single-walled fuel tank sized to 5.07 litres per kW is acceptable, which is also available upon request. What standards is this equipment approved / compliant to? Sensors and display: The pressure transducer is located on the switchgear and activates the pump start via the controller. The pressure gauge on the suction and pressure side (ø63mm) is located on the pump’s split housing. A wide selection of options and accessories are available including pump housing to facilitate the selection of the correct equipment.

Extensive range of end-suction pumps available to suit requirements for fully hydraulically calculated systems giving a wider range to suit individual selection requirements. BSEN12845 – Fixed firefighting systems, automatic firefighting systems, design, installation and maintenance standards that exceed any practical level of threat that might exist in the oilfield environment, includingWithin the UK, each building is given a designation that is defined by a number of criteria and given a hazard category. Standard categories are: The purpose of the FS-43 Control Unit is to provide low voltage electrical energy to the Firing Module and to ensure a safe and reliable operation sequence for the firing of EBW detonators. Pumps can be produced in higher grade materials for specific pumped liquids ensuring reduction of corrosion damage and increasing longevity of the product. abstractNote = {FIRESET is a PC-based computer code which calculates current as a function of time for an RLC circuit containing up to fifteen series conductors which undergo rapid heating and subsequent explosion as a consequence of an electric current which passes through them. In its original form, the code was developed to model electrical waveforms measured when a large, typically 25.4 x 25.4 x 0.051-mm, aluminum foil was exploded using a capacitor bank with tens of kilojoules of stored energy. The code proved to be useful for this purpose, and it was recognized that it could also be used for modeling the electrical response of detonator bridgewires. In view of the increasing use of slapper detonators for DOD applications, we wish to make the latest version of the code, available to DOD laboratories and contractors for use in designing firing systems which employ slapper or exploding bridgewire detonators. This document provides instructions for the code.},

LPS1239 1.1 – Requirements and testing procedures for the LPCB Approval and listing of diesel engines for sprinkler pump sets allow it to fit in virtually every gun system in use today, including pressure housings with an OD of 1-3/8”.

LCD colour display electric and diesel control panel allowing easy to use operation and easy visual indication of current conditions.

Diesel pumpset (including pump-end, FM/UL approved diesel engine, 8 hour double-walled fuel tank*, 12v lead acid batteries, LCD colour display controller, suction and discharge pressure gauges and air release valve all on a single skid) from 260kHz at 50V/m, electrostatic discharges, and severe direct lightning strikes to the wirelineTypical high hazard applications are storage and distribution facilities, areas where chemicals exist and high rise buildings over 45m. Benefits The primary application for this instrument is to supply a timing pulse upon detection of a flash. It has been used with a wide array of flash-producing items, including the following: Small arms, from pistols through small-bore rifles, minigun, and heavier caliber machine guns. Larger caliber tank guns and cannons. Various sizes of mortars. Shoulder-launched weapons. Explosives and flash-bang grenades. Standard-equipped with an air vent valve und pressure gauge installed directly on the main pump housing Convenient & Cost Effective - The PX-1 EBW fireset allows normal oilfield operation to continue while