TP-Link JetStream 24-Port Gigabit L2 Managed Switch with 4 SFP Slots, Supports 24 Gigabit RJ45 ports, Rackmount (TL-SG3428)

Product Information

How to Configure Management VLAN on TP-Link Smart and Managed Switches Using the New GUI 05-18-2023 25766 It's recommended that users stop all Internet applications on the computer, or simply disconnect Internet line from the device before the upgrade. Come gestire i dispositivi Omada in diversi siti utilizzando il Controller Omada SDN via VPN (Controller 5.0 o successivo) 05-02-2023 17174 Yes. Requiring the use of Omada Cloud-Based Controller (Supported by TL-SG2210P v3.2, v5 and above, while is not supported by TL-SG2210P v4)

Three networks with different VLAN IDs have been registered on the router and three computers should be connected to three different networks. Now we need to configure VLAN on the switch. VLAN and port configurations are listed below:Using the Omada controller to configure multiple SSIDs with different VLANs on TP-Link Omada EAPs and Switches to work with a non-Omada gateway(Multi-Net NAT supported) 06-08-2023 17569 Note, if you enter an abbreviation that corresponds to more than one command, the switch will not be able to recognize the command you are trying to execute and you need to enter more. If your computer has a serial port (COM), please connect it to the console port (RJ45) of the switch, with the RJ45 console cable. How to Configure Management VLAN on TP-Link Smart and Managed Switches Using the New GUI 04-26-2023 25766

Use the interface or vlan command to enter this mode from Global Configuration Mode, which allows doing configurations for the specific port(s). V1: 1582.49 BTU/h (110 V/60 Hz) (with 384 W PD connected); 105.78 BTU/h (110 V/60 Hz) (no PD connected)

FAQs

Ports 2, 3, 4 are used as access ports to connect computers. The following configurations describe how to add port 2, 3, 4 to the corresponding VLANs and set PVIDs.

The question mark not only helps complete the command, but also helps display a list of available commands for each command mode, or a list of relevant keywords and arguments for any command. You can use the Auto-Completion feature to enter a complete command, you can also enter part of the command without completion, and the switch will recognize and execute the command automatically. Yes. Requiring the use of Omada Cloud-Based Controller (Supported byTL-SG3428MP v1, v2, v4 and above, while is not supported by TL-SG3428MP v3)If you only have USB ports on your computer, you can get a USB-to-RS232 cable. You may need to install the RS232 driver for the cable, which is provided by your cable vendor. After you finish the configurations, don't forget to save them, otherwise, they will be lost if you power off or reboot the switch. The switch supports configuring IGMP Snooping on a per-VLAN basis. After IGMP Snooping is enabled globally, you also need to enable IGMP Snooping and configure the corresponding parameters for the VLANs that the router ports and the member ports are in. The command is “ip igmp snooping vlan-config vlan-id”.