Was the pusher box installed? If it is not, the cycle control switch will remain up indefinitely, causing this symptom. The RapidStrike released early in the Philippines in May of 2013, due to the release error on the part of the distributor. [ citation needed] If you are excited by Rapid Fire technology with a huge clip to pummel your enemies into submission then we recommend The Nerf N-Strike Elite Rapidstrike CS-18 Blaster. Zombie Targets (Set of Two) for use with Foam Dart Guns, Gel Blasters, Airsoft Target, rubber band gun, foam dart target Despite this, and like other re-released Elite XD blasters, it features the same performance as its original counterpart.

Use flush cuts to chop off wire ends and solder blobs around edges of the two FCG switch PCBs. Do not remove the PCBs. Doing so removes support and insulation from the switch legs and makes wiring more difficult and reliability problems more likely. The barrel of the blaster is notably rifled, similar to the Retaliator barrel extension. It features compatibility with barrel extensions; due to the barrel extension connector being a separate piece of plastic from the main barrel, it can loosen up, resulting in loose fitted barrel extension. It is incompatible with the LongStrike barrel extension, due to inner barrel supports. Alpha Trooper CS-12 • Firestrike • RapidStrike CS-18 • Rayven CS-18 • Rayven Stinger • Rough Cut 2x4 • Spectre REV-5 • Strongarm • Stryfe • Triad EX-3 First of all, there is a lot of talk about motor swaps. The 130 motors that come with the RS aren't too shabby. They play well with battery voltages near 7.2 or 8.4V and deliver quite practical performance. Plus, compared to swaps, they are free.Do not be concerned to damage the PCB edges, lift the pad, etc. Do not cut or damage the 6 switch terminals - everything else is fair game to be leveled. The goal here is not to look good. Once again, I was pressed for time. If you go to the trouble of using 2 separate pieces of wire between terminals, you can get a cleaner install, but this method avoids splices.

While the blaster is more likely to jam, when it does not, it launches darts over a truly elite distance of 90 feet! Another possibility, you connected the negative pusher motor lead to battery positive rather than battery negative.

There are hundreds of Nerf blasters available for you to choose from; however, it can be quite difficult to determine which blaster is the right choice for you. To make matters even more difficult, Nerf releases several new, incredible blasters every year.