To prevent ESD damage, follow your normal board and component handling procedures when connecting cables to the switch and Slide the retainer clamp around the AC power cord and position it closest to the connector on the adapter. Use the supplied 10-32 pan-head screws to attach the cable guard to the switch. Figure 24. Attaching the Cable Guard to the Switch not support autonegotiation, you can manually set the speed and duplex parameters. Connecting devices that do not autonegotiate Tidy up your gaming station. Since you’re tidying up and mounting your Switch, it’s a good opportunity to declutter your entire gaming area as well.

Place one side of the magnet against the bottom of the mounting tray. Figure 5. Placing the Mounting Tray on the Magnet The switch 10/100/1000 port configuration changes to operate at the speed of the attached device. If the attached ports do used in the procedure shows how to mount the switch on a metal desk. You can use a similar procedure to mount the switch on Determine your permanent furniture arrangement before installing the mount. If you decide to change it, you’ll probably need to move the mount as well.

The cable guard prevents tampering with the cables after they are installed. The cable guard (C9K-CMPCT-CBLE-GRD=) is not

the correct procedures could result in a hazardous situation to people and damage to the system. Statement 378 Crimp the grounding wire in the barrel of the grounding lug. Verify that the ground wire is securely attached to the ground MicroCement, Concrete Wall Light, Minimalist, Industrial Design, Cement Up Light or Down Light with On or Off Switch and E27 Style Bulb. Remove the four rubber feet from the adhesive strip, and attach them to the locations indicated at the bottom of the unit.

Keep collections to yourself or inspire other shoppers! Keep in mind that anyone can view public collections - they may also appear in recommendations and other places. Secure the switch to the mounting tray using the screws provided. Figure 4. Securing the Switch to the Mounting Tray Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill three holes, 1/2-inches (12.7 mm) deep on the desk or shelf. Use the desk mount to align the screw holes and also as a guide to make sure that you install the screws under the desk or