Your Hetarae Sadia Electromax would presumably originally have been installed to run from Economy 10. More Add Plumbing Business Post / Search Plumbing Jobs Add Plumbing Video Advertise on PlumbersForums.net For TPOne we have redesigned the heating startup options. Standard startup is default giving instant heat at the scheduled time. New dynamic Delayed and Optimised start features are also selectable. Delayed start will pause the heating startup at the scheduled time dependant on the difference between ambient and required temperature which will decrease energy usage. Optimised start will monitor the difference between ambient and required temperature and will calculate the best time to start heating to hit setpoint at the scheduled time. The model number you quote is hard wired, for wireless operation you would need the RF version plus the RX1 receiver wired to the boiler.

Danfoss Getting Smart with Dad | Danfoss

I have done a bit of looking around online and seen others who have had these issues although no answers. Having just moved into the house this was the system already in place so I'm not overly familiar with it To ensure that the factory programmes are set and the microcomputer is operating correctly it is essential that you press and hold the RESET button before you begin any commissioning or programming. Regarding wireless etc., not sure which it is...... the thermostat and programmer is on the wall, but it doesn't seem wired as it's on the under stairs door and there's no wires coming out from behind it into the cupboard, so is that wireless? It's not bluetooth or freestanding like some.

Danfoss Programmable Room Thermostat TP5000 Si

Superdrug adds new 'VIP Rewards' offers to its existing loyalty scheme – here's what you need to know Is this possible with this thermostat? I can't find out how to do this online. I can see how to put it in 'summer mode' but then I can't turn it on again without that reactivating the annoying coming off programmed settings. This allows the thermostat to be set to run in On/Off mode or for a chrono-proportional cycle rate to be selected. Press + until Option 34 is displayed, use V and Λ to select required setting. I have the same thermostat (DANFOSS TP5000Si) and although I've looked at the manuals available online I can't find out what I want to know.

Fix and troubleshooting | Danfoss Fix and troubleshooting | Danfoss

Prior to mounting the unit the 2 DIL switches on the rear of the unit have to be moved to the required position. The factory presets are shown below. This allows the upper limit of the thermostat setting range to be electronically limited. Press + until Option 30 is displayed, use V and Λ to select required setting. This allows the lower limit of the thermostat setting range to be electronically limited. Press + until Option 31 is displayed, use V and Λ to select required setting.This adjusts the integration time of the PI algorithm to increase control accuracy. It is only active if option 34 has been set to Chrono 3, 6, 9 or 12. It should only be adjusted after seeking advice from the manufacturer. Press + until Option 35 is displayed, use V and Λ to select required setting. Fix at a height of approximately 1.5m from the floor, away from draughts or heat sources such as radiators, open fires or direct sunlight. Both features dynamically adjust according to performance accuracy each day to ensure most acurate control and remove the need for manual setting and adjustment.