Improved MQTT to support multiple port listening, multiple bridge connections, notification settings and added support for custom configuration file The General section is used to set up some of device managerial parameters, such as changing device name. For more information on the General section, refer to figure and table below. Fixed "Used data" showing large negative numbers for disabled mobile interfaces with Data Limit enabled

The deviation from the actual input voltage and the voltage measured by the device is dependent on the input voltage value: EN 300 328 V2.1.1, EN 301 511 V12.5.1, EN 301 908-1 V11.1.1, EN 301 908-2 V11.1.1, EN 301 908-13 V11.1.1, EN 303 413 V1.1.0 Reboot the device. If the reset button is pressed for up to 4 seconds, the device will reboot. Start of the reboot will be indicated by the flashing of all 5 signal strength LEDs together with the green connection status LED.Added netifd, odhcp6c IPv6 routing loop on point-to-point links patches to fix CVE-2021-22161 vulnerability Optional arguments which can be provided for the script. You can include device information with values given below this input field. Added option to send SMS warning messages to Hotspot users authenticated with SMS OTP when specified amount of data is used up Added the possibility to use 2gonly/3gonly/4gonly arguments for cellular service command alongside current 2g/3g/lte arguments RUT955's can be remotely managed through Teltonika's RMS - Remote Management Software - which allows you to access, monitor and manage all your devices within a single platform from your computer, tablet, or phone. DC or PoE Power

Pre-configured firewall rules can be enabled via web-ui, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T

Improved file/section deletion logic: now files are also deleted after deleting a related config section Choose this option if you want to select certificate files from device. Certificate files can be generated in Certificates section. x digital input (0 – 3 V), 1 x digital galvanically isolated input (0 – 30 V), 1 x analog input (0 – 24 V), 1 x Digital non-isolated input (on 4 pin power connector)

Fixed vulnerabilities CVE-2022-3524, CVE-2022-3566, CVE-2022-3567, CVE-2022-39188, CVE-2022-45934, CVE-2022-47929 The CA file generated with this option automatically signs the certificates. In short, this option is used for convenience as it doesn't let the user set any additional parameters for the certificate files. Therefore, it should be used only when no other specific requirements are expected.

Teltonika RMS Remote Management System Licence (1 Month)

While holding the reset button, plug the power cable into the router. Continue holding the button for another 4 seconds. Possibility to use different PDNs for multiple network access and services (not available in standard FW) If you followed all the steps correctly, all panel LEDs should light up. This means that the device is in the bootloader menu state. If that is not the case, repeat the steps again. When set to 'on', the output maintains its new state after reboot (the state is changed in the config file as well). Network protocols: TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet, SMPP, MQTT, Wake On Lan (WOL)