Laser 3799 Spline Bit Set M14 2pc

Product Information

These were spot on for removing Audi diff mountings held up to using on a impact wrench which would chew up poor quality bits . Credit subject to status, UK residents only, Euro Car Parts Limited acts as a broker and offers finance from PayPal Credit. There is nothing wrong with people maintaining their cars, but these cars have modern materials, processes and sometimes need particular tools.

remove rear brake caliper mounting bracket? Which socket to remove rear brake caliper mounting bracket?

Reason for Brake overhaul - Daughter's 2007 Octavia was noted as "All brake discs worn to minimum thiskness", front brake pads were well worn but rear brake pads were still nearly new. strong>

To access finance with Payment Assist, you’ll need to have a web enabled device with you at point of purchase. Thank you to everyone else also, this has given me far more confidence to do the work and what tools are needed! p>

• * Halfords and Halfords couriers deliver Monday to Saturday excluding bank holidays. I take it the inner o-ring is the one that sits in the recess near the top of the piston in the bore and the outer seal is the one that sits behind the handbrake arm.
  
  Thats correct just remove the caliper,the carrier can be left bolted to the vehicle; only needs to come to change the discs, you can clean up the carrier with it still bolted to the vehicle.

  spline bolt as it - BRISKODA How can I remove the caliper spline bolt as it - BRISKODA

  Most other large bolts are 200Nm+180° And should be replaced, as should the 90Nm+90° bolts for the rear carrier. Depending on the depth/amount of any corrosion you may be able to clean it up with some very fine sandpaper. I'm just simply amazed at how many people's advice is to break out the welder or mash it up with some mole grips on this site. And being a bit pretentious i decided to go for drilled and grooved it wasnt any more money so i went for it. The caliper pistons on the MK2 octy (pre FL and FL, they use the same brake systems) need a windback tool, to remove or replace them.Oh, I had sprayed the bolts wherever I could with penetrating fluid, each day for a week beforehand. Push gently on the piston whilst rotating and you will feel the lug on handbrake mechanism locate onto its recess. It'll be the latter that'll be more difficult to find, I reckon, although I think I could modify an existing seal to do the job. I still say for what it costs you should get the up to date version for your chassis number from ErWin if you are actually doing these kind of things yourself. The new seals are an absolute pain to put in, the piston will need to be cleaned also but as mentioned above they will be scored or even pitted.