Press ▲ or ▼ button again to increase or decrease the value and press to back to parameter code display. v=1596529436","width":1000},{"alt":null,"id":7236294672455,"position":4,"preview_image":{"aspect_ratio":1. You'd need an Arduino board (like the Arduino UNO) and an STC-1000 thermostat with the proper hardware version (A400_P).

The first thing that is needed is to upload the sketch Before the connections are made from the Arduino to the STC-1000, the sketch needs to be uploaded to the Arduino. v=1596529432","width":1000},{"alt":null,"id":7236295655495,"position":7,"preview_image":{"aspect_ratio":1. Elitech STC-1000X temperature controller is suitable for aquarium, seafood machine, aquaculture, hatchery/incubator farming, greenhouse planting, brew, ferment, fridge, freezer, slow cooker, AC systems and other scenes that need to control the temperature.

The best way to proceed is to use a vacuum solder sucker and a soldering iron to clean out the solder from the programmer header pads, exposing the holes.

The aim of the comparison between Elitech and the “Generic version” is to find out whether one is just a plain copy or Elitech has some added value. Prevent potential off-flavors: When it’s too hot, the controller switches to cooling mode to regulate the temperature of your fermenter. Under normal operating status, press and hold button for more than 3 seconds to enter parameter setting mode. When the connections are made, connect the arduino to the computer, open the Arduino IDE and open the serial monitor in the Arduino IDE ( Tools -> Serial Monitor). Elitech STC-1000Pro TH temperature controller thermostat with UK/EU/US version can be widely used in areas that need automatic temperature controls such as homebrew, pet breeding, seeding heat mat, aquarium, seafood machine, aquaculture, hatchery/incubator farming, greenhouse planting, brew, ferment, fridge, freezer, slow cooker, etc.This is a straightforward process that involves immersing the heat probe in ice-cold water until it reaches a stable temperature. F3:Compressor delay time:time for wait after reach goal temperature , if you set 3 min temperature controller wait 3 min , after 3 min turn on relay.

If measured temperature temperature set-point, the controller stops heating and cooling indicator is off. You might also be able to clear the holes by heating the pad from underneath with the soldering iron, then rapidly remove the iron once the solder is liquid and quickly blowing out the solder.This is an excellent addition to Starrag’s simulation solutions to avoid expensive machine downtime. STC-1000+ is only compatible with the A400_P version of the STC-1000 as this sports the Microchip PIC16F1828 microcontroller, for which there are open tools and freely available documentation.