Super fast postage, swapped my roadaport for full LED so this was a must. Straight swap got me up and running! Did exactly as it said on the tin, straight forward installation as per the video and fixed the flashing sequence to the correct timing ⏱. Brilliant product, highly recommend!

LED Indicator Relay YAMAHA MT01 MT03 MT07 MT09 TDM 900 LED Indicator Relay YAMAHA MT01 MT03 MT07 MT09 TDM 900

PLEASE NOTE: We have seen many fake LED relays on the market. They look the same but have different components inside and the casing is made from an inferior plastic. We have even tested some where the positive and negative terminals were incorrectly labelled. Please ensure you have a suitable LED relay fitted to your Caterham when upgrading to any type of LED light. As with every modification to your motorcycle, if you are not confident undertaking the work it is always a better idea to take your motorcycle and the indicators to a qualified mechanic. This guide shows you how to bypass the built-in Piaggio indicator relay and fit a universal 2-pin indicator relay instead.You might have been put off making the change in the past because of all the talk about calculating wattage of bulbs and determining which units to buy, however it's not as difficult as it sounds. Fitting new LED indicators is an easy task for anyone with simple electrical knowledge. Suitable replacement for 3 pin flasher relays with 49 (X), 49a (L) and P Connectors. You will need to also connect the earth connection wire. Also available with Positive Earth, please select the required option from the drop down menu. LED motorcycle indicators have a lot of benefits over the OE option, being smaller & lighter units, which allows the designs to be a lot more sharp and modern, plus giving a much brighter flash out on the road. One of the problems with this is you have to get the resistor value just right. If you fit just rear LED lights and get them flashing correctly you may need to change the resistors for different value ones if you then late additionally upgrade the front indicators.

Pin Adjustable LED Indicator Relay Car Turn Signal CF13 3 Pin Adjustable LED Indicator Relay Car Turn Signal

There are many flasher relays available that look the same as this one, and are described as ‘led compatible’ which will not work unless the current draw is around 0.5A. This is less than the 3.5A that a pair of 21W bulbs requires, but still way more than many led equivalents. This relay works with a current of 0.02A so it will still flash even with the tiniest of connected loads, including any led combination. LED lighting draws much less power (load) and lasts way longer than standard incandescent lighting. Replacement of indicator bulbs with LED’s will cause the indicators to flash too fast. This happens because your new LED lights draw such little power. Installing an LED flasher relay specifically designed for LED lights is the easiest method to solve this problem. What about load resistors?

You may also like…

Easy to find an install, does what its intended for, maybe should be sold altogether as a set with the LED lights. Suitable for many other classic or modern 12v cars or applications with standard filament / incandescent bulbs or LEDs or a mix of filament / incandescent bulbs and LED. From innovative motorcycle stands, to cleaners & fluids; we have everything you need to carry out all the maintenance your motorbike needs