On a lawn. If you’re installing lights over a lawn or anywhere else where you can drive a stake into the ground, an easier method is to use 10-foot-long electrical metal tubing poles, and secure each one into the ground with a metal rebar stake. To do this, buy an 18-inch-long rebar stake for each EMT pole, position the poles where needed for support, drive half the stake into the ground with a hammer and slide the hollow EMT pole onto it. You can hang your rosary lights on any type of stranded vertical or horizontal structure. This is great for use as a table or desk light when the sun is going down. If you want your rosary luster to go out at night, you can simply open the blinds, slide the luster in, and enjoy the darkness. 7. Plug In The Outdoor String Lights And Enjoy!

If you want to hang them vertically, you will want to push them outwards. So that they reach a sufficient height.Therefore that they can be balanced properly when the sun goes down. Vertical – If you want your lights vertical, you’ll want to push them outwards. So that they can be suspended by either horizontal supports or even wooden planks. This option is the best for both aesthetic and functional reasons. Keep reading this if you’re planning on adding outdoor rope luster to your landscape or build project. 4. Will To Screw In The Cup Hooks Outdoor string lights are wildly popular, and for good reason! They feel magical and bring a warm, intimate ambiance to any party or outdoor living space.A simple, inexpensive way to attach the string lights to the EMT poles is with cable ties. It’s easiest with a buddy holding the lights up for you so you can work your way across the yard and attach the cable ties as you go. If the EMT pole has a hole in the end, as some do, thread a cable tie through the hole and the end of the pole, and then pull it to form a loose loop around the cord of the lights. In general, you don’t want to tightly pull the cable tie against the cord of the string lights, as this can cause the lights to short-circuit.

foot-long wooden posts or 10-foot-long metal poles (electrical metal tubing, aka EMT or thin-wall, is available at home improvement stores in 10-foot lengths, which you may need to cut) If you want to hang your cafe lights from your house or another wall or fence, simply drill a pilot hole and screw either an eye hook, a cup hook, or a coaxial staple into the wall.

WHAT OUR CUSTOMERS SAY

Hanging outdoor string rope can provide an elegant and festive look to your home or garden. Not only do they add a touch of glamour, but they are also very practical in terms of providing light during the night or in low-light conditions. A downside to many traditional lighting options is that they can be difficult to Install on surfaces such as stucco. However, with the help of a skilled installer, hanging rope lamps can be a simple and cost-effective solution for adding beautiful lighting to your property. Best Tips For Hanging Outdoor String Lights On Stucco

If you are hanging rope lights close to a roofline or other high spot, it is important that you use a sturdy light fixture with a long cord. If the cord is too short, the lamps will be at an awkward angle and may not look as good as it could.You don't have permission to access "http://www.homedepot.com/c/ah/how-to-hang-outdoor-string-lights/9ba683603be9fa5395fab906857f44d" on this server. Hang outdoor string luster on stucco to create a festive atmosphere. Use wire hanger hooks to easily attach the luster to the stucco. Drill small holes into the hooks and screws, then insert the screws into the light fixtures. Line up the hooks with corresponding holes and tighten the screws to secure them in place. Final Thought Some light are more sensitive to illumination than others and even though they may have been designed with thousands of hours of exposure to light, they will still be able to be hung on stucco without getting out of control. 3. Choose The Mounting Locations Solar lights work due to the photovoltaic effect. The most important part of a solar light is the photovoltaic cells of the solar panel. They gather and harvest the sun's energy to charge a battery which powers the LED .

You should also make sure that the type of stucco used is compatible with outdoor lighting. Some types of stucco are porous and may let water into the metal wires in replacement fixtures, causing them to rust.Hanging without a wire: To hang the patio lights without a wire, screw a cup hook into the wall, fence, pergola or tree trunk to use as mounting. (You may need to drill a hole first, before putting in the screw.) My patio dining space at my old house was right next to the house, with no convenient trees nearby. So while we could hang them from hooks on the house side, we really needed some poles on the other side of the patio. If you don’t have walls or trees in just the right spot to hang your string lights, you’ll need to put a little extra effort into making supports for your patio lights.