Because we're talking about painting skirting boards, we'll cover cutting in along a horizontal line first. So this will most likely be painting the top edge of the skirting where it meets the wall. We recommend that you start painting approx. 2 inches (5cm) away from the corners. When you start painting, it is best to use a single stroke. This helps to push the paint from the brush onto the surface and creates a smooth surface upon which the brush can glide. Before you start painting again, make sure the painter’s tape and other methods of protection are still in place. Now, go through the painting process again for the second coat. Does Satinwood Paint Stay White? High-quality satinwood paint is less likely to yellow over time compared to cheaper alternatives. However, all paints are subject to some degree of discolouration due to factors like sunlight exposure and general wear and tear.

Skirting Board Self Adhesive Sealing Tape - The Range

DraughtEx Standard has a profile of 8mm and is suitable for skirting board gaps between 2 and 7mm - More Information. Ogee: Decorative profile typically featuring angled edge that graduated into a more sweeping curve with a flat face at the bottom of the board. Use Painter's Tape for Clean Edges: For crisp, clean edges, use painter's tape along the top edge of the skirting board. Remove the tape before the final coat dries to prevent peeling.On the other hand, if yours is an older home, you may be better opting for a more ornate profile. "Decorative profiles including traditional ogee, ovolo, lambs tongue and torus designs work well in period settings," says Rebecca. Very useful advice, thank you. Can you recommend anything for large gaps between floor and skirting board (apprx 1.5 inches)? It is a very old house and the floors and floor boards are no longer particular even. First Coat: Using a high-quality brush or roller, apply the first coat of paint. If you're using satinwood paint, a foam roller is often recommended for a smoother finish. Alternatively, you could try to fit strips of wood in the gap or cover the gap with beading but given that you’ve gone to so much effort to sand your floor and skirting it would be a bit of a shame. Once you’ve finished one wall, you can do the rest (assuming you’re working a room and not just one wall).

Flexible Skirting Board - Self Adhesive Angle Trim

So, lay your new floor 10mm from your old skirting all the way round the room, then fit the new skirting directly on top of the new floor which will also fit over your original skirting. When cutting skirting boards you will need to know the best way to join them at the corners. External corners face outwards and internal corners face inwards. Each corner needs a different cut for the best results. Do I Need to Rub Down Skirting Boards Before Painting? Yes, it's advisable to rub down your skirting boards before painting. Sanding helps to create a smooth surface for the paint to adhere to and also removes any existing paint or varnish, which can affect the new coat. Use fine-grit sandpaper and always sand in the direction of the wood grain to avoid scratches.Now run the masking tape along the carpet as tight as you can to the skirting board. When you reach the other corner, mark and cut the masking tape so you have a another nice, straight edge. If you have very long walls, do this step in manageable stages of about four to six feet or so. PaintWell increased its Industrial Paints offering with the acquisition of Promain UK Limited, the preferred UK distributor for many of the world’s leading paint and surface coatings manufacturers.