Measure between the door frame and then cut the trim with a hack saw If the floor is wood you can simply use 10mm nails or screws. It is not uncommon that in old houses, water and heating pipes are laid in notched joists just below the floor boards.

Push the edge of the carpet into the space in the lip of the Z-bar positioned over the hard surface.

Before you start it is important to locate any hidden wires or pipes using a pipe and wire detector. Without the bars, the rough edges of the two carpets would be seen and would pose a huge risk of tripping. If you would like some help with how to do home measurements, you can book a virtual consultation with one of our advisors. It’s also a good idea to wear gloves; the nails and pins are sharp and you don’t want to cut yourself. Make sure it’s a secure fit, because the dowel rod is going to act as a rawlplug, giving the nails of the gripper rod something to sink into.

Using a circular saw, if possible, or a good quality hack saw, make a cut from your measurements from the underside of the bar. Make sure you use 19mm nails to lessen the risk of piercing through the floorboard into pipes or cables.Whether you decide to use our fitting arrangement service or get right to it and do it yourself, you will find everything you need to know in this fitting guide. They are fixed around the perimeter of the room and are used to help tension the carpet and hold it in place – this stops the carpet and underlay from moving and rippling. The ideal position is central over the threshold with the join of the two carpets in the middle of the bar. Here’s a couple of tips if you’re choosing the DIY option, and we hope it will help you do the job as it its quite easy if you are “handy”.

Butt the edges together and join them with tape, ensuring that the edges do not overlap and that the underlay is flat and level. In this section we show you how to lay a carpet and how to make sure you get the best overall finish. Many of the tools you may already have in your toolbox and most DIY outlets will sell everything else. It can be tricky to fit carpets into doorways, but if you need help, we’re here to explain how to correctly fit a door bar over the carpet to ensure a seamless, quality finish. For a pipe, cut straight from the carpet edge to the centre of the pipe then press the carpet around it.Available in lengths of 1m, a carpet gripper is a rod that comes with angled nails to provide a firm grip on your floors. Now, on to actually removing the gripper… Starting at one end of the room, use a chisel to get underneath the gripper and gently hammer along the length of the gripper to loosen it up. If in doubt – stick down the gripper and door plates with Gripfill instead of nails in the offending areas. You need a double-edged door bar with grips on both sides to connect carpets in two different rooms in the doorway.