You check the power supply, and everything looks fine; then, you press the buttons several times with short and long presses, but the coffee maker does not turn on. When the orange light (yellow on some models) lights up steadily, the Dolce Gusto indicates the need to proceed with descaling. If this problem happens to you, do not panic: it is only a failure of the boiler to manage the temperature. Does this mean that the hot water will only be in contact with the stainless steel but not with the aluminum? So, the noise from Dolce Gusto coffee machines does not imply any fault, no problem, nothing that can be “solved”.

POD COFFEE MACHINES - Nescafé Dolce Gusto

Usually, too much limescale has built up in the Thermoblock; the heating element can no longer heat up as it did when it was new. Another of the most common faults with Dolce Gusto coffee machines, and many other brands, is when the coffee machine does not even turn on the lights on the buttons.

If you have been using your coffee machine for a while and notice that the coffee is not as hot as it used, the number one solution is always to descale it. It is important to assess where this leakage is coming from (water tank, capsule holder or underneath the machine). To be noticed that if the descaling mode is activated and the machine is switched off without doing the descaling, the power button will turn back to green and the counter is reset.

Dolce Gusto flashing red, what to do? - Lereparator Dolce Gusto flashing red, what to do? - Lereparator

When you start your machine and during the rise in water temperature, the on/off button flashes red for about 30 seconds. If that doesn’t solve the problem, turn off the power completely and wait five minutes before turning it back on again. And if we take into account that 25% of all capsule coffee machines worldwide are in the United States, we can conclude that more than 80 million capsule coffee machines have been sold worldwide in the last ten years. The fault of excessive vibration in Dolce Gusto coffee machines is not very frequent, but the control board is damaged. For my automatic machine, the user manual states that when you descale the machine, you only use the Hot button.I have encountered and solved many problems related to the maintenance and repair of my own household equipment and appliances. A variation of the above problem is that sometimes the coffee machine switches on with the buttons glowing normally but suddenly switches off after a few seconds. To avoid this, you’ll need to press down and hold the power button for about 30 seconds, which should then turn it green again ready for use. The reason why the capsule holder leaks on the side is probably due to the fact that the connection between the needle and the water tube is not perfectly tight any more. When you descale the Dolce Gusto coffee machine, it will mix water and the descaler through the interior components of the machine, and clean it out.

Dolce Gusto Troubleshooting | The Complete Guide 2023. Dolce Gusto Troubleshooting | The Complete Guide 2023.

To do this, select on the head the maximum amount of water from the machine, drop an empty container under the head of the machine and press the Cold Water position (blue button) and wait for the end of the stream. All you have to do is disconnect the component from the electronic board and position your multimeter in the ohmeter position. Although we said you could continue preparing coffees, seeing that light continuously illuminated can be very annoying, so we will show you how to turn it off. Choose the appropriate water level (the amount of water is specified on each adapted beverage capsule). Wait for 20 minutes to release the pressure, lift up the locking handle, remove capsule holder and throw away the capsule.It may be that the electronic card no longer supplies voltage to the resistor, so that the latter can no longer heat up.