Do not adjust the nozzle too low, which would leave the prints remaining on the PC sticker extremely difficult to clean.

Sovol SV01 - Ultimaker Community of 3D Printing Experts Sovol SV01 - Ultimaker Community of 3D Printing Experts

This one is a simple magnet with a printing surface on top, similar to what you would get with an old Ender 3. I thought the slicer set the first part of the code (jerk, acceleration, etc), so you shouldn’t need that, I don’t think.I know I am excited to try out a direct drive printer, and I think I will need to pick up a BLtouch for this, since it has support baked in.

Sovol 3D SV01 3D Direct Drive 3D Printer – Ender 3 Pro Killer? Sovol 3D SV01 3D Direct Drive 3D Printer – Ender 3 Pro Killer?

After running ABL for leveling the printer, it stays consistent and it’s not hard to get perfect first layers.All these measurements were taken with a Blitzwolf smart power socketwhich indicates the power draw, and it can also be used for remotely powering on and off the printer.

Sovol SV01PRO Direct Drive 3D Printer Auto Leveling Silent Sovol SV01PRO Direct Drive 3D Printer Auto Leveling Silent

a direct drive extruder is generally considered to be more compatible with a wider range of filaments.

The bottom side of the duct is really close to the print, and because of that, I had four failed prints during the review period. Finally, I also need to mention that the extruder stepper motor is getting hot after a few hours of printing. During my time with the Sovol SS01 Pro, I tuneda few IdeaMakerand Prusa Slicer profiles using the tools available in the 3D Printer Calibration Guide using IdeaMakerarticle.

Sovol SV01 3D Printer with Direct Drive Extruder

In the example below, you can see how much of an impact Linear Advance has on print quality (model is not printed on the SV01 Pro).What’s more important here is the binding issues I had for the Z-axis which can be seen on the top of the print. I would just like to see something similar out of the box, especially considering that the SV01 Pro is considered a “pro” machine. Whether you use Marlin firmware as the driver for your open or closed-source product, you must keep Marlin open, and you must provide your compatible Marlin source code to end users upon request. I removed all the parts and assemblies and we went ahead and started moving onto the assembly process. I designed a model of my own, set bed temp to 60 dec C, used a brim, adjusted level one more time whilst the bed was hot.